anonymous
My feedback
3 results found
-
47 votes
The upcoming maintenance update to include a new "Skip Equivalent Combinations" setting to further reduce the list of connections in order to exclude similar paths.
An error occurred while saving the comment -
4 votes
Depends on feature requests:
- https://railmodeller.uservoice.com/redirect/suggestions/7672158
- https://railmodeller.uservoice.com/redirect/suggestions/12450792
anonymous supported this idea · -
29 votesanonymous supported this idea ·
An error occurred while saving the comment anonymous commentedyes but set the base board in the upper left corner of the canvas, offset down and to the right 6 scale inches so the base board upper left corner is at zero/zero. Much easier to figure layout in real world dimensions and still see the length and width arrows of the baseboard.
Using Kato Unitrack there is the expansion track (20-050) as of last update you can insert the track section and use the cut-off too to cover the expansion range (78-150mm). On the layout your software can compute the gap, and if it is range cut it to exactly the correct distance. In real life, you just connect one side and slide the other side to click in, much simpler than the fiddling of rail modeler. It would be nice to have RM compute the gap and draw the rail segment connected to both ends, as simple as IRL